Jet Pump Support - Sea-doo 2003 XP DI Shop Manual

GTX DI and GTX 4-TEC Models
Apply Loctite RTV silicone sealant (P/N 293 800
066) as indicated by the shaded areas in the next
illustrations. Follow also the torquing sequence as
shown in the same illustrations.
GTX 4-TEC SERIES MODELS
GTX DI MODELS
NOTE: Apply Loctite RTV silicone sealant
(P/N 293 800 066) as indicated by the shaded area.
SMR2003-046_16_02A.FM
Subsection 02 (ADJUSTMENT AND REPAIR)

JET PUMP SUPPORT

Removal
Remove jet pump. Refer to JET PUMP.
Remove inlet grate and riding plate.
Remove ball joint, boot, nut, half rings and O-rings
from steering cable.
F05K02A
TYPICAL
1. Unscrew nut
Remove ball joint, boot, nut, half rings and O-rings
from reverse cable.
Remove boot and nut from VTS sliding shaft (RX
DI and XP DI models).
Disconnect water supply hose, water return hose
and bailer hoses.
Remove nuts, lock washers and flat washers re-
taining jet pump support.
F07L0AA
TYPICAL
1. Remove nuts
www.SeaDooManuals.net
Section 16 HULL/BODY
1
1
16-02-33