Jet Pump Support Removal; Jet Pump Disassembly - Sea-doo SP 5876 Shop Manual

Section 09 PROPULSION SYSTEM
Sub-Section 01 (JET PUMP)

JET PUMP SUPPORT REMOVAL

HX Model Only
Remove ball joint, boot, nut, half rings and O-rings
from steering cable.
F05K02A
1. Unscrew nut
Disconnect water supply and water return hoses,
drain hose and bailer hoses.
F05J0DA
Disconnect exhaust hose.
09-01-8
Remove nuts, lock washers and flat washers re-
taining jet pump support.
Using a heat gun, heat jet pump support until it is
possible to pull it off.
1

JET PUMP DISASSEMBLY

split, break, porosity, cavitation, deformation, dis-
tortion, heating discoloration, wear pattern, miss-
ing plating, missing or broken needles in needle
bearing, water damage diagnosed by black-col-
ored spots on metal parts, etc. Renew any dam-
aged part. As a quick check, manually feel
clearance and end play, where applicable, to de-
tect excessive wear.
9,10, Venturi and Screw
Remove 4 retaining screws and withdraw venturi.
1. Remove screws
www.SeaDooManuals.net
F05D04A
NOTE : Whenever removing a part, visually
check for damage such as : corrosion, crack,
1
F01J4ZB