Table of Contents
Advertisement
Tilt the watercraft slightly to the rear
so that the water can flow out of the
bilge completely.
It is suggested to drain bilge when the
watercraft is on a ramp.
CAUTION: Make sure the drain
plugs are properly secured prior
to launching the watercraft in the
water.
18) Jet Pump Nozzle
Jet pump nozzle turns side to side via
rider input at the handlebar. This pro-
vides directional control when engine
is running.
1. Jet pump nozzle
2. VTS adjuster
19) VTS Adjuster
(if so equipped)
A trim knob is used to change the jet
pump nozzle trim angle manually and
to adjust the ride to suit water condi-
tions and driver preferences. Refer to
illustration above.
1. Trim knob
There are reference numbers to indi-
cate nozzle position and to facilitate
fine tuning.
F05J02Y
1. Trim knob
2. Reference numbers
20) Jet Pump Water Intake
The water is drawn in by the impeller
through this opening. The water in-
take grate minimizes the entry of for-
eign objects into the propulsion sys-
tem.
Keep away from intake grate while
engine is on. Items such as long
hair, loose clothing or person-
al flotation device straps could
potentially become entangled in
moving parts resulting in severe
injury or drowning.
_____________________
2
WARNING
1
39
Advertisement
Table of Contents
