Console Installation; Level The Treadmill - Precor 700 Series Assembly Manual

Console installation

To attach a console, refer to the installation instructions shipped with your console.
Once you have attached all the cables, follow the steps below to complete
assembly of your treadmill.
To attach the console:
1. Secure the console to the dash assembly using four screws
Figure 24
2. Place the dash cover onto the back of the dash assembly and attach it using
the two screws previously removed plus five screws
Figure 25

Level the treadmill

IMPORTANT
Adjust only one rear foot at a time. DO NOT extend the adjustable feet more than
3/4-inch (2 cm). Adjusting the rear feet cannot compensate for extremely uneven
surfaces. If you cannot make the running surface level and stable, move the
treadmill to a level surface.
.
To level the treadmill:
1. Use a 3/4-inch open-end wrench to loosen the jam nuts on the rear feet and
adjust as needed to level the treadmill. Then retighten the jam nuts.
Figure 26
from the hardware kit.
2. Plug the power cord into an appropriate outlet.
IMPORTANT
The treadmill requires a 20-amp individual branch circuit grounded per NEC
(National Electric Code) guidelines or local region electric code.
13