Console Installation; Level The Treadmill - Precor Experience Series 700 Line Assembly Manual

Console installation

To attach a console, refer to the installation instructions shipped with your console.
Once you have attached all the cables, follow the steps below to complete assembly
of your treadmill.
To attach the console:
1. Secure the console to the dash assembly using four screws
2. Place the dash cover onto the back of the dash assembly and attach it using the
two screws previously removed plus five screws
.
Figure 22
from the hardware kit.
Figure 23

Level the treadmill

Important Adjust only one rear foot at a time. DO NOT extend the adjustable feet more
than 3/4 inch (2 cm). Adjusting the rear feet can't compensate for extremely uneven
surfaces. If you can't make the running surface level and stable, move the treadmill to a
level surface.
1. Use a 3/4-inch open-end wrench to loosen the jam nuts on the rear feet and
adjust as needed to level the treadmill. Then retighten the jam nuts.
2. Plug the power cord into an appropriate outlet.
Important The treadmill requires a 20-amp individual branch circuit grounded per
NEC (National Electric Code) guidelines or local region electric code.
Figure 24
11