Mounting A 5U Or 10U Extension; Installing Tie Bars - HP StorageWorks MSL6000 Series Reference Manual

Figure 17

Mounting a 5U or 10U extension

c. Attach the large tie bar (beveled edge to the inside corner of the PTM base unit and
extension) using four mounting screws (see
Figure 18

Installing tie bars

10.Repeat step 9 for each extension.
11.Remove the bottom stop standoff from the PTM base unit and then attach it to the corresponding
mounting hole (see
12.Secure the belt tensioner ramp and idler pulley to the extension using the two previously
removed screws (see
13.Secure the belt tensioner ramp and idler pulley springs using the two previously removed screws
(see Figure 16 on page 26).
Figure 18) in the last unit of the extended PTM.
Figure 16 on page 26).
MSL6000 series pass-through mechanism reference guide
Figure 18).
27