Installing a Longer Belt to an Extended PTM
To install an extended belt:
1.
On the extension belt tensioner ramp and idler pulley base, compress the springs until the holes
in the tensioner ramp are aligned with the holes in the base of the tensioner.
2.
Insert a large paper clip through the holes. This sets the idler pulley to the zero position (see
Figure
19).
Figure 19
Tensioner ramp/idler pulley zero point
3.
Thread the timing belt through the top of the belt tensioner ramp and idler pulley and then
through the motor drive pulley. Make sure the belt teeth engage both pulleys (see
Figure 21
4.
Position the media elevator car over the belt block access cutout (see
5.
Position the ends of the timing belt under the media elevator car at the midpoint of the belt block
access cutout.
6.
Turn over the PTM.
28
Installing the PTM
on page 29).
Figure 20
Figure 14
on page 25).
and