HP StorageWorks MSL6000 Series Reference Manual page 24

Pass-through mechanism, tape library

Hide thumbs Also See for StorageWorks MSL6000 Series:

Table of Contents

NOTE:

During this procedure, make sure you save all screws, the PTM base unit bottom bracket,

and the belt tensioner ramp/idler pulley springs and associated hardware. These items must be

reused when adding extensions.

Remove the bottom plate from the PTM base unit (see

Figure 13

Removing the bottom plate from the PTM base unit

Slide the media elevator car to the top of the PTM base unit (see

the PTM base unit has the drive motor on it.

NOTE:

The media elevator car should now be positioned over the belt block bracket access cutout

next to the PCB and drive motor.

Installing the PTM

Figure

13).

Figure

14). Note that the top of

Table of Contents