Adding Extensions To A Ptm Base Unit - HP StorageWorks MSL6000 Series Reference Manual

b. Using a stubby or right-angle #2 Phillips screwdriver, remove the screws securing the cover
plate to the inside of the drive cage of each library chassis.
c. Using a #2 Phillips screwdriver, remove the screws that secure the PTM cover plate to the rear
of each library chassis (see
NOTE: Do not discard the PTM cover plate or screws. If the unit ever requires shipping, the PTM
cover plate must be reinstalled.
Figure 12 Removing a PTM cover plate (10U models)

Adding Extensions to a PTM Base Unit

To add extensions to a PTM base unit, you will need a clean, flat work area such as a table or work
bench. The surface should be long enough to support the full length of the PTM base unit and all
extensions.
Figure 12 on page 23).
MSL6000 series pass-through mechanism reference guide 23