Trap Receiver Configuration; Back To Main Menu; End Of Interseptor Pro Configuration - jacarta interSeptor Pro User Manual

interSeptor Pro

6.2.12 Trap Receiver Configuration

If you want to send SNMP traps from the interSeptor Pro to an SNMP network management system,
the IP address of the management station must be added to the interSeptor Pro list (see Figure 6-
13).

6.2.13 Back to Main Menu

Press "0" to return to the main menu

6.2.14 End of interSeptor Pro Configuration

When configuration is complete press "0" to terminate the console connection
NOTE: After completing all the settings, press "0" to terminate the connection without
starting interSeptor Pro again or "6" to terminate the connection forcing the interSeptor
Pro internal program to start again. At this point, the initial interSeptor Pro configuration
is complete.
NOTE: If you want to restore the default interSeptor Pro configuration data set in the
factory, press "5": Reset Configuration to Default.
40
Figure 6-13 Access Control Table
.