Lcd Screen Overview; Lcd Screen In Idle Mode; Lcd Screen In Operation Mode - jacarta interSeptor Pro User Manual

interSeptor Pro
2.3

LCD Screen Overview

You can view and configure the main system settings using the LCD screen and the Down and Set
buttons on the front of the interSeptor Pro (see on page 8 for exact location of the switches). For
additional security the LCD controls can be password protected with a default password of 0000.
The LCD screen operates in two modes: idle mode and operation mode.

2.3.1 LCD Screen in Idle Mode

When the system is started, the LCD screen is in idle mode. In this mode, system information, along
with temperature and humidity alarm data for each connected EMD device is displayed. Press the
Down button to scroll through the displayed information.

2.3.2 LCD Screen in Operation Mode

Press the Set button to enter operation mode. You can perform system configuration through the
menus available in operation mode.
Press the Down button to scroll through the settings menus.
Press the Set button to enter settings menus and adjust values.
To exit a settings menu without making any changes, press the Set and Down buttons
simultaneously.
See the following for all available settings menus in operation mode.
No.
1
2
3
4
5
6
7
8
10
Setting Menu Description
IP Address Set the IP address
Net Mask Set the net mask
Gateway Set the gateway
HTTP Security Enable or disable login
and password request
for HTTP access
Telnet Control Enable or disable the
TELNET protocol
DHCP Enable or disable the
Function DHCP protocol
Power Saving Enable or disable the
power saving function
Back to Idle Return to idle mode
Figure 2-1 LCD Screen: Operation mode menus
Default
192.168.001.001
255.255.000.000
192.168.001.254
Enabled
Enabled
Disabled
00060
N/A