Installation; Installing The Interseptor Pro Via Lan; Led Overview - jacarta interSeptor Pro User Manual

Environmental monitoring system for data centers, server rooms, racks. 8-port, 16-port, 24-port versions
Hide thumbs Also See for interSeptor Pro:
Table of Contents

Advertisement

2

Installation

To install the interSeptor Pro on a network and change its configuration, you need a workstation
running Microsoft Windows (9x, ME, NT4.0, 2000, XP or later). To configure the interSeptor Pro,
connect it to your LAN and follow the instructions in the subsequent sections.
2.1

Installing the interSeptor Pro via LAN

Follow the steps below to install the interSeptor Pro via a LAN connection.
1. Ensure your workstation has a web browser installed and is connected to your LAN via a
hub/router/Switch.
2. Connect one end of a network cable to the LAN port on the front of the interSeptor Pro and the
other end to your hub.
3. Set the DIP switches of the interSeptor Pro to OFF by moving the switches upward.
4. Connect one end of the supplied CAT 5 network cable to any of the device board ports on the
front of the interSeptor Pro and the other end to the RJ45 port on an EMD.
5. Insert one end of the power connector to the AC-In socket on the rear of the interSeptor Pro.
Connect the other end to a power socket.
Upon successful connection, you can configure the interSeptor Pro via the web browser from any
workstation connected to the same LAN as the interSeptor Pro. For further details, please refer to
Chapter 3.
2.2

LED Overview

When you have successfully installed and powered on the interSeptor Pro, check the power LED and
LCD screen to ensure it is operating properly. The power LED should be on (Green/Red depend on
status) and "System Power On" should be displayed on the LCD screen.
The power LED is a bi-color LED, whose changes state depending on the alarm level.
1. Power LED Status
LED color
Blinking
Green
Green
Red
Red
Note: If the sensor or output device is enabled from
the Configuration page but the device is not
connected, the LED will be red since the interSeptor
Pro will treat this condition as a 'communication loss '.
Alarm Level
No
None
Yes
Informational
Yes
Warning
No
Critical
Installation
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents