Snmp Control; Parameter Group Configuration - jacarta interSeptor Pro User Manual

6.2.6 SNMP Control

From the control group menu, enter 9 to access the SNMP configuration
No.
1. SNMP Control
2.
After completing these settings, press "0" to return to the configuration menu.
NOTE: The SNMP port applies to the SNMP management port to be used.
SNMP traps are not affected using this setting and always use UDP port 162.

6.2.7 Parameter Group Configuration

From the configuration menu press "3" to modify the SNMP identification information and the speed of
reading data from interSeptor Pro (see Figure 6-8)
No Function
1. sysContact
2. sysName
3. System Location Alphanumeric string
4. Poll Rate
Figure 6-7 SNMP Configuration Menu
Function Description
Enable/disable SNMP
Configure port for
SNMP Port
SNMP access.
Figure 6-8 Parameter Configuration Menu
Description
Alphanumeric string
Alphanumeric string
Amount of time in seconds between sensor polls. 1
Example/Remark
Enable
access.
Configuration
161
Example/Remark
Technical Support Team
Multi-Port Sensor
Technical Support Lab.
37