4) Notifications
1. Setting up a trap
The SP8 can send an SNMP trap message to two different hosts. Whenever the status changes
for a sensor that is online, a trap message can be sent.
To get to the entry point of this tutorial complete the following:-
1) Log into the web interface as administrator
2) From summary page select the Traps tab
a) On the "traps" tab there are two configurable trap receivers ("Trap 1", "Trap 2")
b) The traps have various fields to configure. These are explained below.
Send Trap: - toggles whether the SNMP trap is on or off
Destination IP: - The destination IP address that the trap message will be sent too.
Community: - This is the Community of the host that will receive this trap. This is often set to
public
- 9 -
SP8 Manual