Schedule Of Device Board Screens - jacarta interSeptor Pro User Manual

Configure the following settings:
Device Name: Enter the device name.
Normal Start-up: Select On(Close) or Off(Open) to configure the normal status of the device.
Action: Select to Enable or Disable the digital output.
Manual Control: Select Turn On to turn on a device manually or Turn Off to turn it off.
Password: Enter a password for each digital output. It must be 4 digits long, within the range
of 0000 – 9999. The default password is 0000.
Postpone: Enter a value in seconds by which the alarm trigger time can be postponed if
necessary. If set to zero, the digital output will be activated as soon as an alarm is triggered.
Extend: Enter a value in seconds before which the digital output changes back to start up
status after an alarm is triggered. If set to zero, the digital output will be deactivated as soon
as an alarm is triggered.

3.3.2 Schedule of Device Board Screens

The Schedule of Device Board-1, Schedule of Device Board-2, and Schedule of Device Board-3
pages allow you (as administrator) to set a schedule by which alarms can be disabled.
Figure 3-9 Schedule of Device Board 1 page
Note: The following instructions apply for each of the
Schedule of Device Board-1, Schedule of Device
Board-2, and Schedule of Device Board-3 pages.
Monitoring interSeptor Pro
17