Configuration; Configuring Interseptor Pro Via Telnet - jacarta interSeptor Pro User Manual

6 Configuration

6.1 Configuring network settings for the interSeptor Pro
You must set an IP address, Subnet mask, and gateway via the LCD screen on the front of the
interSeptor Pro to connect it to your network before you can begin using the system.
1. Press the Set button on the front of the interSeptor Pro so System Config displays on the
LCD screen.
2. Press the Set button.
3. Press the Down button until IP Address displays on the LCD screen.
4. Press the Set button.
5. Enter the IP address given to you by your network administrator. Press the Set button to cycle
the number, and the Down button to move to the next number.
6. Press the Set and Down buttons simultaneously to exit the setting menu once you have
entered the IP address.
7. Repeat steps 1-5 above to enter the net mask and gateway (listed as Net Mask and Gateway
in the system configuration menu).
8. Configure any of the other system configurations you require (see figure 2-1 LCD Screen:
Operation mode menus for details), then select Back to Idle to complete the system setup.
9. Protect future unauthorized access to network settings by inputting a 4 digit password via the
telnet menu.

6.2 Configuring interSeptor Pro via Telnet

When you have installed the interSeptor Pro via network, you can configure the interSeptor Pro via
Telnet by the following steps.
1. Make sure you have a PC with the TCP/IP network installed.
2. Run command shell (i.e. Windows MS-DOS prompt).
3. By default DHCP is disabled, but if enabled the interSeptor Pro will try to acquire and IP address
via DHCP on the network.
4. Type "Telnet < interSeptor Pro IP address>" and press Enter.
Figure 6-1 Connectivity Page
Note: If there is no DHCP network service on the
network, contact your network administrator to get an
IP address for your interSeptor Pro and set the IP
address manually.
Configuration
33