Reading The Alarm Log From A Terminal Or Computer - Powerware Ferrups FE/QFE UPS User Manual

Troubleshooting
Table 15. Inverter Codes
Inverter Code

Reading the Alarm Log from a Terminal or Computer

To display the Alarm Log on a terminal or computer, you can use the
alarmlog or logs command (see "Entering Commands from a Terminal
or Computer" page 44). These commands display up to 20 log entries in
a table. For example, the log might look like this table:
Active
No
No
No
The table shows whether the alarm is active now (Active), the date and
time of each alarm, how long it lasted (Duration), and what caused the
alarm (Code/Event).
You can also display parameter 25 to view the Alarm Log; this display is
the same as the control panel display.
64
Meaning
T System Test
B Brownout
L Line Loss
M Manual
F Frequency
R Reset
EventDate EventTime
08/25/1993 11:25:32
08/24/1993 12:13:18
08/24/1993 12:05:07
Powerware ® FERRUPS FE/QFE UPS (500 VA–18 kVA) User's Guide
Explanation
UPS went to inverter to test the batteries.
AC input voltage was too low.
AC input power was lost.
The inverter was started manually.
Input frequency was too high or too low.
A system reset was performed.
Duration Code/Event
00:00:45 J-User Test Alarm
00:01:08 A-Low Battery
00:08:11 B-Near Low Battery
Rev A www.powerware.com