Powerware Ferrups FE/QFE UPS User Manual page 52

Communication
Command Short
Form
paramkeywords pk
password pw
program pr
remote rm
shutdown sd
or
sd a
shutdown autostart
shutdown cancel sd c
shutup sh
status s
systemmode _ sm
systemmode auto sm a
systemmode off sm f
systemmode inverter sm I
systemmode sm l
linecondition
*If you change parameter 39 to "Yes," this command requires a User password.
46
Password Function
Depends Displays all parameters and their keywords (the names you can use with
on commands). You can also display a range of parameters by entering the
parameter
numbers or names of the starting and ending parameters.
password
None Allows you to enter the User Password. Typing
the current password.
Example:
Depends Lets you set the value of any parameter. You must enter the appropriate
on password before you reset the value. See the Password command above.
parameter
Format: PR [parameter # or name] [newvalue]
password
Example:
None Configures the RS-232 port so the connected terminal works like a
control panel.
None* Shuts down the UPS output in 60 seconds (if you enter shutdown alone)
or the number of seconds you specify after the command. The READY
indicator flashes until the UPS shuts down. If you specify autostart, the
UPS restarts shortly after power returns.
None* Cancels a shutdown started with the shutdown command.
None Turns off audible alarm.
None Shows date, time, system status, present system mode, active alarms,
and the value of various system parameters.
None* Typing
You can use
below.
None* Enters the Auto mode. This is the normal FERRUPS UPS mode. In this
mode, the UPS provides conditioned AC power to your equipment; if
there is a power outage, the UPS is ready to switch to battery power.
None* Enters the Off mode. In this mode, the UPS is not providing power to your
equipment, but you can still use the UPS control panel.
None* Enters the Inverter On mode. In this mode, the UPS is converting DC
battery power to AC power for your equipment.
None* Enters the Line Condition mode. In this mode, the UPS provides
conditioned AC power to your equipment, but it does not switch to
battery power if there is a power outage. Instead, the UPS sounds a Low
AC Out alarm.
Powerware ® FERRUPS FE/QFE UPS (500 VA–18 kVA) User's Guide
enters the User Password.
resets the time (parameter 0) to 8:15 a.m.
alone displays which system mode is now active.
with , , , or to enter one of the modes
Rev A www.powerware.com
alone clears