Summary of Contents for Powerware Powerware 300 VA
Page 1
POWERWARE ® 3110 300–700 VA User’s Guide www.powerware.com...
Page 2
Fax: +358-9-452 665 68 Powerware is a registered trademark of Powerware Corporation. ECopyright 2001-2003 Powerware Corporation, Raleigh, NC, USA. All rights reserved. No part of this document may be reproduced in any way without the express written approval of Powerware Corporation.
Do not remove or unplug the input cord when the UPS is turned on. This removes the safety ground from the UPS and the equipment connected to the UPS. Powerware 3110 User’s Guide Rev B www.powerware.com ® W A R N I N G...
DO NOT protect laser printers with the UPS because of the exceptionally high power requirements of the heating elements. C A U T I O N The UPS ground (earth) conductor carries leakage current from 3110 provides protection against many power Powerware ® 3110 User’s Guide Rev B www.powerware.com...
Figure 3 and Figure 4 identify features of the 230V (European) models, which have a connector for the input line cord as well as IEC output receptacles. Powerware 3110 User’s Guide Rev B www.powerware.com ® µ indicator illuminates indicating µ...
Page 8
Installation RJ-11 or RJ-45 Surge Protectors Circuit Breaker Communication Port USB Port Power Cord On/Standby Switch Figure 2. 120V Model Side Panel Powerware ® 3110 User’s Guide Rev B www.powerware.com...
Connect the other end of the USB cable to the USB port on your computer. 2. Install the LanSafe software and USB drivers according to the instructions provided with the Powerware Software Suite CD. Powerware 3110 User’s Guide Rev B www.powerware.com...
DB-9 Communication Port Powerware offers an accessory interface kit that allows you to connect many types of computer systems to the UPS communication port. For specific information on Powerware interface kits, call your service representative. Contacts consist of open collector circuits capable of switching up to +30 Vdc, 6 mA resistive load.
230V models. 1. Connect the input connector of the equipment you are protecting to the jack labeled IN. 2. Connect the output connector to the jack labeled OUT. Powerware 3110 User’s Guide Rev B www.powerware.com ®...
Page 12
Features Powerware ® 3110 User’s Guide Rev B www.powerware.com...
Replace batteries with the same number and type of batteries as originally installed in the UPS. DO NOT DISCONNECT the batteries while the UPS is in Battery mode. Powerware 3110 User’s Guide Rev B www.powerware.com ® W A R N I N G...
Page 14
Figure 5. Removing the Battery Cover and Battery – Use a screwdriver to remove the four screws – Press down on the battery cover tabs and slide the – ), and slide the battery back into the case. Powerware ® 3110 User’s Guide Rev B www.powerware.com...
For more information, contact your local recycling or hazardous waste center. Powerware 3110 User’s Guide Rev B www.powerware.com ® W A R N I N G C A U T I O N...
C H A P T E R 4 PECIFICATIONS Powerware Corporation reserves the right to change specifications without prior notice. Table 2. Electrical 120V Model Nominal Voltage Power Factor Voltage Range Online: 90–152V On Battery: 0–100V and 152–160V Nominal Frequency...
Page 18
Online: Less than 40 dBA typical at one meter On Battery: Less than 45 dBA typical at one meter 450 joules EN 50091-1-1 and EN 60950 UL, cUL Powerware ® 3110 User’s Guide 230V Model IEC 61000-4-5, Level 3 NEMKO, CE EN 50091-2 Rev B www.powerware.com...
The battery is discharged and battery power is not available. 3 beeps every 5 minutes. Powerware 3110 User’s Guide Rev B www.powerware.com ® What to Do None. The UPS is operating in Normal mode. S Wait for utility power to return.
Page 21
Troubleshooting If repair is required, you will be given a Returned Material Authorization Powerware 3110 User’s Guide Rev B www.powerware.com ®...