Troubleshooting; Alarms - Powerware Ferrups FE/QFE UPS User Manual

C H A P T E R 9
T
ROUBLESHOOTING
When your FERRUPS UPS detects an alarm condition, the UPS displays
the alarm with the following indications:
the ALARM indicator on the front panel (and the control panel if you
have one) illuminates
sounds an audible alarm
displays an alarm message on the control panel (if you have one).
NOTE If the control panel does not display the message, press [CLEAR] until you
reach the scrolling display.

Alarms

When an alarm occurs, follow these steps:
1. Find out which alarm condition the UPS is detecting.
2. Find the alarm in Table 14 and follow the instructions to
3. To silence the alarm:
4. After the alarm condition is cleared, turn the alarm beep back
NOTE If you do not turn the alarm beep back on, the UPS is not able to sound an
alarm code the next time there is an alarm.
Powerware FERRUPS FE/QFE UPS (500 VA–18 kVA) User's Guide
®
If you have a control panel, you can read the alarm on the
display.
If you do not have a control panel, listen to the alarm code;
the UPS sounds the Morse Code for the alarm letter.
resolve the problem.
FE/QFE 500 VA–3.1 kVA models:
the UPS rear panel to the OFF position.
Press [CTRL]-[5] [ENTER] [ENTER]
FE/QFE 4.3–18 kVA models:
on the control panel.
on (using either the switch or the control panel).
Rev A www.powerware.com
Turn the Alarm Silence Switch on
59