Powerware Ferrups FE/QFE UPS User Manual page 49

Table 6. DB-25 Port Settings
Specification
Connector
Baud Rate
4. Turn your terminal on or run your terminal emulation
5. Press [ENTER] on your keyboard a few times to verify that the
6. To control or monitor the UPS, simply type the desired
Table 7. Keystroke Commands
Pause displays that take more than one screen.
Powerware ® FERRUPS FE/QFE UPS (500 VA–18 kVA) User's Guide
Standard Setting
25 pin D (female) wired as DCE.
Format ASCII, 8 bits, 1 stop bit.
Most significant bit set to 0.
1200
Parity None
Duplex Full
software. Then press [ENTER] on your keyboard; a prompt
appears on the screen. The prompt varies depending on your
current password level:
=> Normal prompt
User=> User Password has been entered
UPS responds.
command and press [ENTER].
Table 7 shows what keystrokes to use as you type commands or
view displays. See Table 8 for more information on UPS
commands.
Action
Delete last character typed.
Delete line.
Resume scrolling. (Turn Pause off.)
Rev A www.powerware.com
Communication
Adjustable to
Standard setting or
7/8 bits, 1/2 stop
50–38400
Odd, Even, or None
Full or Half
Key Sequence
[BACKSPACE] or [CTRL]-[H]
[CTRL]-[X]
[CTRL]-[S]
[CTRL]-[Q]
43