Powerware Ferrups FE/QFE UPS User Manual page 40

Operation
Parameter Sample Display
Number
14 14 XfmrTemp 28c
15 15 Unit ID
Network #1 UPS
16 16 FullLoad% 075
17 17 Watts 374
18 18 PF 0.73 Dist
19 19 VALimit 500
20 20 #PwrOut 1
21 21 #OvrLds 0
22 22 SysHrs 00000
23 23 InvMin 0000.0
34
Password Parameter Name
(Short Form)
Change Not xfmrtemp
Allowed (xt)
None unitident
(See "Entering (id)
Passwords" on
page 28.)
Change Not fullload
Allowed (l)
Change Not watts
Allowed (w)
Change Not powerfact
Allowed (pf)
Change Not valimit
Allowed (val)
Change Not powerout
Allowed (po)
Change Not overloads
Allowed (ol)
Change Not syshours
Allowed (sh)
Change Not invmin
Allowed (im)
Powerware ® FERRUPS FE/QFE UPS (500 VA–18 kVA) User's Guide
Explanation
The temperature of the transformer. The UPS
sounds an alarm and shuts down if this value
is too high.
This parameter is only active on some
models; for other models, the display always
shows -63c.
UPS ID. An identification string that can be
configured for use with your network.
Percent of Full Load. The percentage of the
UPS's total capacity that is actually being
used by your equipment.
The total "real power" your equipment is
drawing from the UPS.
The power factor of your equipment; the
difference in the way it draws voltage and
current. Power factor is equal to Watts Out
(parameter 17) divided by VA Out
(parameter 5). This parameter also tells
whether the power factor is leading (Lead),
lagging (Lag), or distortion (Dist).
The maximum volt-amps the UPS can supply
to your equipment at the present power
factor. The UPS sounds an alarm when VA
Out (parameter 5) is higher than this value.
The number of times there has been a loss of
input power since you started the UPS.
The number of times the UPS has sensed an
overload; that is, the number of times VA Out
has been greater than VA Limit.
The total number of hours the UPS has been
operating, regardless of mode. This number
does not increase when the UPS ON/OFF
switch is in the OFF position.
The total number of minutes the inverter has
run since startup.
Rev A www.powerware.com