Disabling Of Auto Paper Selection; Auto Selection Setting Of Tray That Is Supplied The Paper - Sharp MX-7090N User Manual

SYSTEM SETTINGS►SYSTEM SETTINGS
Initial Tab Copy Setting
This is used to set the default image shift width (tab width) for tab copying.
Specify a value from 0" (0 mm) to 1" (25 mm) in increments of 1/8" (3 mm).
Disabling of Registration/Deletion of Program
This is used to prohibit the deletion and change of copy settings stored in job programs.
Disabling of Bypass-Tray in Duplex Copy
Disables the use of the bypass tray when making 2-sided copies.
The bypass tray is often used to feed label sheets, transparency film, and other special media for which 2-sided copying
is prohibited. If a sheet of one of these special media enters the reversing unit, a misfeed or damage to the unit may
result. If special media for which 2-sided copying is prohibited is often used, it is recommended that you enable this
setting.

Disabling of Auto Paper Selection

Disables the Auto Paper Selection function.
When this setting is enabled, automatic selection of paper that is the same size as the original on the document glass or
in the automatic document feeder does not take place.

Auto Selection Setting of Tray that is Supplied the Paper

When this setting is enabled and paper is loaded into a tray while the machine is on standby in copy mode, that tray is
automatically selected.
Disabling Registration of Custom Image
Disables storage of a custom image.
Disabling sending while copying
Disables the Image Send function during copy.
7-78