Quick Settings; Subnet Mask; Default Gateway; Smtp Authentication - Sharp MX-7090N User Manual

SYSTEM SETTINGS►SYSTEM SETTINGS
Network Settings

Quick Settings

Select the minimum required settings for the machine connection to the network.
IPv4 Settings
When using the machine on a TCP/IP (IPv4) network, use this setting to configure the IP address of the machine.
DHCP
Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration
Protocol)/BOOTP (Bootstrap Protocol). When this setting is enabled, it is not necessary to manually enter an IP
address.
• If DHCP/BOOTP is used, the IP address assigned to the machine may change automatically. If the IP address changes,
printing will not be possible.
• If the machine is used on a TCP/IP network, be sure to enable the
IPv4 Address
Enter the IP address of the machine.

Subnet Mask

Enter the IP subnet mask.

Default Gateway

Enter the default gateway address.
DNS Settings
Primary Server
Enter the IP address of primary DNS server.
Secondary Server
Enter the IP address of secondary DNS server.
Domain Name
Enter the domain name where the selected DNS server exists.
SMTP Settings
Primary Server
Enter the IP address or the host name of the primary SMTP server.
Sender Name
Enter the sender name.
Sender Address
If data transmission has failed, the undelivered e-mail may be returned from the server. Enter an e-mail address (a
single address only) to receive such undelivered mails. Usually, enter the e-mail address of system administrator.
Enable SSL
If is selected, the SMTP-over-TLS encryption communication can be used by STARTTLS command.
This requires the server to support the STARTTLS command.
To allow SSL communication, set the "Port Number" to the same port number as the normal SMTP.

SMTP Authentication

If is set, the SMTP server authentication is carried out.
"TCP/IP (page
7-129
7-131)" below.