Charge The Battery; Test The Connection - Uniden XDECT SSE45 Owner's Manual

Connect the Power and Telephone Cords
Connect the base AC adaptor to the power jack and the telephone cord to the TEL
LINE jack. Route the cords as shown below:
For Desktop Use
1. Plug the AC adaptor into a standard 240V AC power outlet, and connect the
telephone cord to a standard telephone wall jack.
2. If you are mounting the phone on the wall, place the mounting slots over the pins on
the wall plate, and slide the base down to lock it into place.

Charge the Battery

1. Unpack all handsets, battery packs, and battery covers.
If you need to remove a cover, press in on the notch
and slide the cover down and off.
2. Line up the battery connector with the jack inside the
handset; the connector only fits one way.
3. Push the connector in until it clicks into place; tug
gently on the wires to make sure the battery is securely
connected.
4. Replace the battery cover and slide it into place.
5. Use an AC adaptor to connect the power jack on the base to a regular indoor (240V
AC) power outlet. Connect any chargers the same way.
6. Place a handset in the base with the display facing forward. If the battery icon
does not begin cycling through levels, reseat the handset or connect the base to a
different outlet. For two or more handsets, place each handset in a charger.
# Charge all handsets completely (about 15 hours) before using.
Connect the Telephone Cord
Use the telephone cord to connect the TEL LINE jack on the base to a standard
telephone wall jack.

Test the Connection

1. Pick up the handset and press TALK/FLASH. The handset sounds a dial tone, and the
display shows Talk.
• If you don't hear a dial tone or the display shows Check Tel Line, check the
connection between the base and the phone jack.
2. Make a quick test call. (Press TALK/FLASH to hang up.)
• If there's a lot of noise, check for interference (see page 32).
3. Test all handsets the same way. If you can't get a dial tone, move the handset closer
to the base.
For Wallmount
7