Using An Optional Headset; Staying In Range - Uniden XDECT SSE45 Owner's Manual

1. Press MENU/OK, select Messages and then choose Voicemail. The system
automatically dials the voice mail access number you entered.
2. If you have not set one up, then the Edit V-mail No. screen displays. You can enter
the voice mail access number and press MENU/OK to confirm. OR
You could also go to the Advanced Setup menu and select the option Edit Voicemail,
to enter or edit the voice mail access number.
# Contact your telephone service provider for your voice mail access number.
After you listen to your messages, the message icon disappears, the dial tone returns
to normal, and/or the charge LED on the Handset stops flashing. If not, you can reset it
by going to the menu, and selecting the option Advanced Setup and then choose Reset
VMWI menu. To confirm, select Yes.

Using an Optional Headset

You can use a standard telephone headset (2.5mm diameter jack) with your handsets.
To purchase headsets, visit our website; www.uniden.com.au for Australia
• To install a headset, remove the headset jack cover and insert the headset plug into
the jack.
• Just make and receive calls as usual, and use your headset to talk to the caller after
the call connects.
• While you connect a headset, the handset automatically mutes the earpiece.

Staying in Range

Your system will alert you when you are out of range (or about to go out of range).
If...
the handset and base are
connected (intercom call) and no
signal from the base
the handset is in Talk mode and
moves out of range
the handset and base are in
standby mode and the handset
does not get a signal from the
base for 15 seconds
audio deteriorates
you are trying to go off-hook
26
Then...
the handset sounds an error tone and unavailable
at this time displays.
the outside line is put on Hold for 30 seconds and
then dropped. The LCD alternately displays, End
of Range, and a prompt message displays, "Move
towards Base".
the LCD alternately displays, Out of Range and
Check Base Power.
the handset sounds an error tone. The LCD
alternately displays, End of Range, and Move
toward base.
An error tone sounds. The LCD alternately
displays, Out of Range and Check Base Power.