Installing Your Phone; Charge The Battery - Uniden XDECT 7015WP Series Owner's Manual

Charge the Battery

The handset's rechargeable battery is already installed. Before you
can charge the battery, you have to power it on.
11 Remove the cardboard spacer.
21 Press the power on/off (activation1 pin
according to the directions on the label.
31 Remove the label once the handset is powered on.
Save the power on/off pin in case you need to change the
handset's power status later (i.e., to power off the handset when
it will not be used for a long time). Use the plastic power on/off
pin or a blunt-tipped object like an uncurled paper clip to press
the power on/off toggle through the rubber seal. Do not use a
sharp object; sharp objects might puncture the rubber seal and
jeopardize the handset's waterproof status.
41 Connect the base AC adapter to the
51 If you have accessory handsets, connect the AC adapter to the
charger's
adapter might already be connected.)
61 Plug the other end of each adapter into a standard 240V AC
power outlet.
71 Place the handset in the base with the display facing forward.
The display on the handset should turn on.
If...
the handset
display does
not turn on
Charge the handset completely (about 16 hours) before using it.

Installing Your Phone

jack and set the cord into the notch. (This
DC IN 9V
Try...
- Checking the AC adapter connection.
- Seeing if the outlet is controlled by a
wall switch.
- Check handset activation at step 2
above.
jack on the base.
DC IN 9V
3