Getting Started; Installing Your Phone; Charge The Battery - Uniden DECT1015 Owner's Manual

CAUTION! Risk of explosion if battery is replaced by an incorrect type!
Dispose of used batteries according to the instructions. Do not open
or mutilate the battery. Disconnect the battery before shipping this
For more details, see the Important Information section.
product.

GETTinG STarTED

Installing Your Phone

1. Unpack all handsets, battery packs,

Charge the Battery

and battery covers. If you need to
remove a battery cover, press in on
the notch and slide the cover down
and off.
2. Line up the battery connector with the jack inside the handset.
(The battery connector will only fit one way.)
3. Push the connector in until it clicks into place; tug gently on the
wires to make sure the battery pack is securely connected.
4. Replace the battery cover and slide it into place.
5. Connect the AC adapters to the
the charger for DECT1015+1). Set the plug(s) into the notch(es).
6. Plug the other end of the adapters into standard 240V AC outlets.
7. Place one handset in the base (and the other in the charger for
DECT1015+1) with the display(s) facing forward. The display on
each handset should light up; if it doesn't, reseat the handset or
try plugging the AC adapter into a different outlet.
#
Charge all handsets completely (about 15 hours) before using
them.
Use the telephone cord to connect the
Connect the Telephone Cord
standard telephone wall jack.
jack on the base (and on
DC IN 9V
jack on the base to a
TEL LINE
3