Installing Your Phone; Charge The Battery - Uniden XDECT 8005WP Series Owner's Manual

Charge the Battery

The handset's rechargeable battery is already installed.
Before you can charge the battery, you have to power it on.
1)
Remove the cardboard spacer.
2) Press the power on/off (activation) pin according to the
directions on the label.
3) Remove the label once the handset is powered on.
Save the power on/off pin in case you need to change the
handset's power status later (i.e., to power off the handset
when it will not be used for a long time).
Use the plastic power on/off pin or a blunt-tipped object
like an uncurled paper clip to press the power on/off toggle
through the rubber seal. Do not use a sharp object; sharp
objects might puncture the rubber seal and jeopardize the
handset's waterproof status.
Connect the AC adaptor to the charger's DC IN 9V jack and
4)
set the cord into the notch. (This adaptor might already be
connected.)
5) Plug the other end of the adaptor into a standard 240V AC
power outlet.

Installing Your Phone

4