Getting Started; Installing Your Phone; Test The Connection; Charge The Battery - Uniden D3097 Series User Manual

GETTING STARTED

Installing Your Phone

Charge the Battery

1. Unpack all handsets, battery packs,
and battery
covers. If you
need to
remove a
cover, press in
on the notch
and slide the
cover down
and off.
2. Line up the battery connector with
the jack inside the handset; the
connector only fits one way.
3. Push the connector in until it clicks
into place; tug gently on the wires
to make sure the battery is securely
connected.
4. Replace the battery cover and slide it
into place.
5. Use an AC adapter to connect the
power jack on the base to a regular
indoor (120V AC) power outlet.
Connect any chargers the same way.
6. Place a handset in the base with the
display facing forward. If the battery
icon does not begin cycling through
levels, reseat the handset or connect
the base to a different outlet. For
2 or more handsets, place each
handset in a charger.
#
Charge all handsets completely
(about 15 hours) before using.
Connect the Telephone Cord
Use the telephone cord to connect the
TEL LINE jack on the base to a standard
telephone wall jack.
Downloaded from www.Manualslib.com manuals search engine

Test the Connection

1. Pick up the handset and press TALK/
FLASH. The handset sounds a dial
tone, and the display shows Talk.
- If you don't hear a dial tone or the
display says
Check Tel Line,
the connection between the base
and the phone jack.
2. Make a quick test call. (Press TALK/
FLASH to hang up.)
- If you keep hearing a dial tone,
change to pulse dialing.
- If there's a lot of noise, check for
interference (see page 22).
3. Test all handsets the same way. If
you can't get a dial tone, move the
handset closer to the base.
Changing to Pulse Dialing
Your phone uses tone dialing by
default. If your phone company uses
pulse dialing, you need to change your
phone's dial mode.
1. Press MENU/OK and select
Setup (see page 7 for using the
menus).
2. Select Dial Mode
hear a confirmation tone.
To send DTMF tones during a call (e.g.,
for an automated response system),
press to temporarily switch to tone
dialing. When you hang up, the phone
automatically returns to pulse dialing.
Attaching Optional Wall-Mount
Bracket
You can order a wall-mount bracket
from the Uniden website. Follow the
instructions that come with the bracket.
check
Advanced
then Pulse. You'll
English - 3