Installing Your Phone; Charge The Battery - Uniden DECT 1730 Series Owner's Manual

Charge the Battery

1. Unpack the handsets, battery packs,
and battery covers.
2. If you need to remove the cover, press
in on the notch and slide the cover down
and off.
3. Line up the battery connector with the
jack inside the handset; the connector
only fits one way.
4. Push the connector in until it clicks into
place; tug gently on the wires to make sure the battery is securely
connected.
5. Replace the battery cover and slide it into place.
6. Use the AC adaptor to connect the power jack on the base to a regular
indoor (240V AC) power outlet. Connect any chargers the same way.
7. Place the handset in the charger with the display facing forward. If the
display doesn't light up, then reset the handset.
#
Charge the handset completely (about 15 hours) before using it.
Connect the Telephone Cord
Use the telephone cord to connect the TEL LINE jack on the base to a
standard telephone wall jack.
Test the Connection
1. Pick up the handset and press TALK/FLASH. The handset sounds a
dial tone, and the display shows Talk.
- If you don't hear a dial tone or the display says Check Tel Line, check
the connection between the base and the phone jack.
2. Make a quick test call. (Press END to hang up.)
- If there's a lot of noise, check for interference (see page 26).
3. Test all handsets the same way. If you can't get a dial tone, move the
handset closer to the base.
Attaching the Base Stand
Align the mounting slots found at the bottom
of the base with the mounting hooks on the
stand and gently push till the base locks into
the stand.

INSTALLING YOUR PHONE

5