Installing Your Phone; Charge The Battery - Uniden XDECT 8155 Series Owner's Manual

Charge the Battery

1) Unpack all handsets, battery packs, and
battery covers. If any battery cover is already
on the handset, press in on the notch and
slide the cover down and off.
2) Line up the red and black wires on the
battery pack with the label inside the
handset.
3) Push the connector in until it clicks
into place; tug gently on the wires to
make sure the battery pack is securely
connected.
4) Place the cover over the battery
compartment and slide it up into place.
5) Connect the base AC adaptor to the
ADAPTOR jack on the rear of the base.
6) If you have accessory handsets, connect a charger AC adaptor to
each charger's DC IN 9V jack and set the plug into the notch as
shown.
7) Plug the other end of each adaptor
into a standard 240V AC power outlet.
8) Place a handset in the base and
any accessory handset(s) in the
charger(s) with the display(s) facing forward. The CHARGE light on
the handset(s) should turn on.
6

INSTALLING YOUR PHONE

Red
Black