Train - devention DEVO-7 User Manual

Press R or L(if servo keep neutrally,etc 0%),to decrease or increase the position
amount which centers on the neutral point of servo.The settable range is 125%,and
0% is the servo's neutral position.
Setting finishing DN to set other channel.
The setting methods for other channels are the same as above
Press EXT to exit after finished
Note: checking whether all the actions when fail safe happened correct is a must after
the setting is finished.It is dangerous to use full throttle,especially after fail safe taken
place
3.15（TRAIN）
Two DEVO-7 transmitters working together can execute the training function to meet
the requirements for the beginner. The setting method is shown as below:
1）Data copy
Using the wireless copy function of the two DEVO-7 transmitter, the model saved in
the trainer's transmitter can be transmitted to the trainee's to ensure the model
parameters are exactly same.
2）Linkage
Insert the signal wire from the trainer's transmitter into the DSC socket of the trainee's
transmitter. Turn on the transmitter and a linkage icon will be shown on the boot
screen. Showed as following interface.Find out the trainee's model data.
linkage icon
Turn on the power of the trainer's transmitter,find out the trainee's date and let the
trainer's devo 7 fly the aircraft normally. After testing flying normal, insert one end of
the signal wire into DSC socket at the rear face o the trainer's.
DEVO-7 Page 80 of 170