Gyro Sensor - devention DEVO-7 User Manual

Point parameter adjustment
Please see below picture, POS〈 R setting. Point parameter is adjustable in range ±
100% by press R or L key.
Press DN to enter the next setting POS – R, there are two choice by press R or L:
Inhibit and Active. Press Active if you want adjust, then press DN to enter value
adjustment interface.
Press R key (0% means no adjusting), a minus value shows, it means the amending
direction is downward, Press L key, a plus value shows, it means the amending
direction is upward. The range is ±100%.
Press DN respective after finish POS—R setting, there is POS--1、POS--M、POS--2、
POS--L、POS>L setting, please repeat above steps.
Press EXT to exit after finished.

3.9 Gyro sensor

Setting method:
Press ENT key in main interface to get twinkling main menu, then press UP or DN
until flash FUNCTION appears, press ENT to enter function menu. And then Press UP
or DN, it will come out bright GYRO, press ENT to enter MODE MENUsurface, then
press R or L to select Manual setting or Automatic setting
DEVO-7 Page 129 of 170