devention DEVO-7 User Manual page 17

transmitter's model data to the trainee's transmitter, this promise the the model data
between two transmitters is same. Refer the copy method to the second part of
helicopter "2.4 model wireless copy" and do the following steps:
2）Linkage
Insert the signal wire from the trainer's transmitter into the DSC socket of the trainee's
transmitter. Turn on the transmitter and a linkage will be shown on the boot screen.
Show as below. Find out the trainee's model data.
Linkage Display
Turn on the power of the trainer's DEVO-7. Find out the trainee's model data, and
then let the trainer's DEVO-7 bind with the assigned model, fly it normally. Then turn
off the power Insert the other end of the digital signal wire into the trainer's DEVO-7,
and then turn on its power. A linkage icon will be shown as below:
3） Setting for training function channels
Trainee is available to get full or part of flight control power to the aircraft model via
setting the training function channel in the trainer's DEVO-7. Below is the setting
method:
Press the "ENT" in the main interface, It will come out the flashing "Function" menu;
press UP or DN to make the main interface come out the flashing "TRAIN" menu;
Press "ENT" to enter the function channel. Touch UP or DN, choose the required
channel, press R or L to change the control, INT is forbidden, ACT is granted. Press
"EXT" to exit after accomplished setting.
DEVO-7 Page 17 of 170