Travel Adjust; Sub Trim) - devention DEVO-7 User Manual

turn for AILE, THRO, RUDD, GEAR, PITCH, GYRO and so on. The setting are the
same as above, Press EXT to finish it.

3.2Travel Adjust

Press ENT to enter Main Menu, press UP or DN until "FUNCTION" flash, and then
press ENT to enter Function Menu; Press UP or DN button to flash "TRVAD"; Press
ENT button to enter the options for Channel names and flashing travel range. Press R
or L to change the setting value of travel range; Press DN button, there are travel
range setting options in turn for AILE, THRO, RUDD, GEAR, FLAP, GYRO and so on.
The setting are the same as above, here we take the ELEV picture for example as
below. EXT it for finish.

3.3 (Sub Trim)

Sub Trim is used to make parallel movement of the neutral point of the servo. But we
advise you to mechanically adjust the servo bell crank if offset is far away from the
neutral point of servo. Because servo would be damaged if excessive usage of the
sub trim and beyond its range.
Setting: Press ENT to enter Main Menu, press UP or DN until "FUNCTION" flash, and
then press ENT to enter Function Menu; Press UP or DN to flash "SUBTR"; Press
ENT to enter the options for Channel names and flashing neutral point value. It is
possible to change the neutral point setting value through R or L button,if the direction
DEVO-7 Page 110 of 170