Training Function - devention DEVO-7 User Manual

Remove the 6 fixed screws in the base plate.Below are shown the inside views of left
and right throttle sets, respectively. Use cross screwdriver to loosen and remove
Linkage Fixed Screw, Screw F, Screw G, and Throttle Control Spring in left throttle set,
respectively, and then mount them in the corresponding positions in right throttle set.
And then adjust the stick tension according to your habit.
2）The data switch
In the main surface touch the "ENT" Icon, it will come out the flashing "System". Press
the"ENT"Icon to enter System Menu; and then press the UP or DN to enter the
flashing " , press "ENT" and then select the mode you desire. Press
STMOD" menu
UP or DN, then come out the flashing " MODE1" or " MODE3", press "EXT" icon to
exit.
The switch from right-hand throttle to left-hand throttle is finished after both the
MECHANICAL and ELECTRONIC switches changed, respectively. And the
transmitter is ready to normally work now.
Note: Pay attention to the strength when removing and adjusting the screws.
Excessive strength may damage them.

9.0 Training function

Two DEVO-7 transmitters working together can execute the training function to meet
the requirements for the beginner. The setting method is shown as below:
1）Data copy
First, use the wireless copy function between two DEVO-7 to copy the main
DEVO-7 Page 16 of 170