Setup Report Interval When Park Is Triggered - Sanav MU-201 User Manual

4.9 Setup Report Interval When Park Is Triggered

When the park function is activated, user can use this command to setup report interval. For the detail, please take a look
at following instruction.
Setup format：#「username」,「Password」,「Function Code」, 「intervals (sec)」, 「Total number of report」*
Example: #username,0000,16,60,60*
The table 4.9.1 describes the meaning of each segment in the message above.
Text Keyed In SMS
#
username
0000
16
Interval(sec)
Total number of report
*
The table 4.9.2 shows each confirmation message reply after setup
Situation
Setup Succeeds
MU-201 is in Emergency Mode
Description
Start sign.
Default ID of MU-201.
If you have changed the Username, please use the updated one.
Default password.
If you have changed the password, please use the updated one.
Mode 16 is to set interval when Park is triggered
Maximum 65000 seconds
1-9998 times; 9999 is infinite
End sign.
Table 4.9.1 The explanation of each segment of command
Message Reply
setup OK. Device Move report setting is updated.-16-Park Report Setting,3.947V
in emergency, Move report setting is not allowed.-16-Park Report Setting,4.021V
20