Table of Contents
Advertisement
4.12 Setup Geofence Coordinate
Users can setup the Geofence by using this command. The Geofence is defined as a round area. Therefore, the
coordinates is the center and the radius is defined in meter.
Setup format：#「username」,「Password」,「gf1~10」, 「Latitude」,「N or S」, 「Longitude」, 「E or S」, 「meters」,
「IN/Out mode」*
Command: #username,0000,gf1,2458.9741,N,12125.6460,E,500,1~3*
The table 4.12.1 describes the meaning of each segment in the message above
Text Keyed In SMS Description
Start sign.
#
username
0000
Gf1
Geofence setup mode. You can input gf1, gf2, gf3, gf4...gf10 to define each Geofence range. There
are 10 sets of Geofence can be pre-defined.
2458.97411
Latitude (unit:ddmm.mmmmm)
N
N = North, S = South
12125.64601
Longitude (unit:dddmm.mmmmm)
E
E= East , W= West
500
500 meters in radius
1
1~3
2
3
*
End sign.
If you would like to enable/disable the Geofence Function, it can be done by sending the following SMS command:
Command: #username,0000,gf,on*
#username,0000,gf,off*
Once the device receive the above SMS command, the Geofence Detection will be disabled.
The table 4.12.2 shows each confirmation message reply after setup
Situation
Setup Succeeds
MU-201 is in Emergency Mode
Default ID of MU-201.
If you have changed the Username, please use the updated one.
Default password.
If you have changed the password, please use the updated one.
It will trigger the alarm when the tracker is outside of the geofence.
It will trigger the alarm when the tracker is inside of the geofence.
It will trigger the alarm when the tracker is either outside or inside of the geofence.
Table 4.12.1 The explanation of each segment of command
Message Reply
setup OK. Device is in Geofence mode.,3.937V
setup OK. Geofence mode has been deactivated.,3.946V
in emergency, Geofence mode cannot be activated.,3.920V
23
Advertisement
Table of Contents
