Report Interval Setup - Sanav G-19 User Manual

4.3 Report Interval Setup

ID Report Int Report Frequency
#Username,0000,3,002,12*
Password Interval Command
Use this SMS message to set up the interval and frequency for Auto Report function.
#: Start sign
ID: Username is the default ID of G-19.
Password: Default Password is "0000".
Interval Command: You have to input "3" to set up the report interval.
Report Interval: The Auto Report interval. This parameter must be 3 digits. The minimum
unit is 002 minutes and maximum is 120 minutes. For instance, if you setup the interval for "002",
G-19 will send SMS message every 2 minutes to the indicated cellular phone. To cancel Auto
Report function, set the interval as "000". The default setting of auto report is also off.
Report Frequency: This function is to setup how many times G-19 will report to the user in Auto
Report and Parking function. This parameter must be 2 digits. For instance, if you setup the
report frequency for "02", G-19 will send SMS 2 times to the indicated cellular phone and then
stop. If you set up this value "00" the G-19 will stop Auto Report.
*: End sign
When the auto report of G-19 is setup successfully, G-19 will reply a SMS message:
Username setup OK. G-19 auto-report.
But if fail, G-19 will reply a SMS message:
Username setup fail.
When G-19 is in Emergency Mode, auto report is not allowed. Anyone want to start the auto
report will be replied:
Username in emergency, auto-report not allowed.
11