Setup Over Speed Detection - Sanav MU-201 User Manual

4.10 Setup Over Speed Detection

Use this command to set up the Over Speed Detection Setting; please notice that this is for "Setup" only, you have to send
another command to activate the function. Once the Over Speed detection is activated, MU-201 will start to report
according to interval set below.
Setup format
:
#「username」,「Password」,「Function Code」,「Speed Limit」,「Unit」,「Interval(s)」,「Total Report」*
Example: #username,0000,11,100,km,60,2*
The table 4.10.1 describes the meaning of each segment in the message above.
Text Keyed In SMS
#
username
0000
11
100
km
60
2
*
The table 4.10.2 shows each confirmation message reply after setup
Situation
Setup Succeeds
MU-201 is in Emergency Mode
Description
Start sign.
Default ID of MU-201.
If you have changed the Username, please use the updated one.
Default password.
If you have changed the password, please use the updated one.
Mode 11 is to set speed limit
Speed Limit
Speed in km/hr; you can also input "mi" (miles) or "nm" (nautical miles) for different unit.
Report time interval, 60 seconds
Send out 2 reports according to time interval when over speed occurred.
End sign
Table 4.10.1 The explanation of each segment of command
Message Reply
setup ok. Device Speed limit is updated.-11-Speed Limit,3.965V
in emergency, Speed limit setting is not allowed.-11-Speed Limit,3.936V
21