Operation - ADJ Stinger II User Instructions

SYSTEM MENU (continued)
LED -
With this function you can have the LED display turn off after 10 seconds.
1. Press the MENU button until "LED" is displayed, press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or DOWN buttons to select "ON" to keep the LED
display on at all times, or "OFF" to switch to have the LED display switch off after 10 seconds.
TEST -
This function will run a self test program.
1. Press the MENU button until "TEST" is displayed, press ENTER.
2. The fixture will now run a self test.
DISP -
This function will reverse the display 180º.
1. Press the MENU button until "DISP" is displayed, press ENTER.
2. Press ENTER to "flip" the display. Press ENTER to "flip" it again. Press ENTER when you have made your
desired setup.
3. Press ENTER to confirm. To make you LED display reappear again press any button.
FHRS -
With this function you can display the running time of the unit.
1. Press the MENU button until "FHRS" is displayed, press ENTER.
2. The running time of the fixture will now be displayed. Press MENU to exit.
VER -
Use this function to display the Software version of the unit.
1. Press the either the MENU button until "VER" is displayed, press ENTER.
2. The display will show the software version.
RSET
- This function will reset the unit.
1. Press the MENU button until "RSET" is displayed. Press the ENTER button and the unit will reset itself.

OPERATION

Universal DMX Control: This function allows you to use a universal DMX-512 controller to control the
patterns, rotation and strobing. A DMX controller allows you to create unique programs tailored to your
individual needs.
1. The Stinger II is a 2 DMX channel channel modes; a 2 channel mode and 9 channel mode. See pages 13-
14 for detailed description of the DMX values and traits.
2. To control your fixture in DMX mode, follow the set-up procedures on pages 6-7 as well as the set-up
specifications that are included with your DMX controller.
3. Follow the instructions on page 9 to set the DMX address.
4. For longer cable runs (more than a 100 feet) use a terminator on the last fixture.
5. For help operating in DMX mode consult the manual included with your DMX controller.
Sound Active Mode: This mode allows a single unit or several units linked together, to run to the beat of the
music.
1. Press the MENU button until "Soun" is displayed, and press ENTER.
2. Press the UP or DOWN buttons to either activate sound active mode or deactivate, and press ENTER. The
unit will now run to the beat of the music.
3. The sound sensitivity can be adjusted by pressing the MENU button until "Sose" is displayed, and then
press ENTER. Use the UP or DOWN buttons to adjust the sound sensitivity, 0 being the least sensitive, and
99 being the most sensitive.
Show Mode: This mode allows a single unit or several units linked together, to run to a built-in program.
1. Press the MENU button until "Shnd" is displayed, and press ENTER.
2. Press the UP or DOWN buttons to find your desired show and press ENTER. The unit will now run your
chosen built-in program.
A.D.J. Supply Europe B.V. – www.americandj.eu – Stinger II Instruction Manual Page 11