Status Signalling - 2N Helios IP Audio Kit Installation Manual

Connection:
®
Connect the 2N Helios IP Security Relay
To the intercom active output (OUT1 or OUT2) , or
To the intercom relay output with a 12 V DC serial external power supply.
Connect the electric lock to the
To the active 12 V / 700 mA DC output, or
To the relay output with a serial external power supply.
The device also supports a Departure button connected between the 'PB' and '-
HeliosIP' terminals. Press the Departure button to activate the output for 5 seconds.

Status signalling:

Green LED Red LED
blinking off
on off
blinking blinking
on blinking
Configuration:
Connect the 2N
output; refer to the
®
the 2N Helios IP Security Relay
Press and hold the
put the device in the programming mode (both the red and green LEDs are
blinking).
2N TELEKOMUNIKACE a.s., www.2n.cz
®
2N Helios IP Security Relay
Status
Operational mode
Activated output
Programming mode – waiting for initialisation
Error – wrong code received
®
Helios IP Security Relay
Configuration Manual
is on or blinking.
®
2N Helios IP Security Relay
to the intercom as follows:
to the properly set intercom switch
. Make sure that one LED at least on
Reset button for 5 seconds to
output as follows:
35/49