Configuring Wireless Security; Rear Panel - SMC Networks SMCD3GN3 Administrator User Manual

Configuring Wireless Security

The front panel has a WPS button for configuring wireless security automatically. Pressing
this button for 5 seconds automatically configures wireless security. If the client device
supports WPS Push Button Configuration (PBC), press the button on the client within 60
seconds to automatically configure security on the client.
After pressing this button for 5 seconds, the WPS LED on the front panel flashes. When a
client joins the network successfully, the LED remains ON until the next WPS action or the
device reboots. If no client joins, the LED stops blinking after 4 minutes.

Rear Panel

The rear panel of the SMCD3GN3 Wireless Cable Modem Gateway contains a reset button
and the ports for attaching the supplied power adapter and making additional connections.
Figure 2 shows the rear panel components and Table 2 describes their meanings.
⊇
Figure 2. Rear View of the SMCD3GN3 Wireless Cable Modem Gateway
Table 2. SMCD3GN3 Wireless Cable Modem Gateway Rear Panel Components
Item
⊇ USB
ETH 1 - 4
⊄
Reset button
⊂
Cable
⊆
Power
∈
SMCD3GN2 Wireless Cable Modem Gateway Administrator Manual
錯誤! 尚未定義樣式。
⊄
USB 2.0 high-speed port for storing configurations externally.
Four 10/100/1000 auto-sensing RJ-45 switch ports. Connect devices on your local area network
such as a computer, hub, or switch to these ports.
Use this button to reset the power or restore the default factory settings (see "Restoring Factory
Defaults," below). This button is recessed to prevent accidental resets of the Gateway.
Connect your coaxial cable line to this port.
Connect the supplied power cord to this port.
14
⊆
⊂
Description
∈