Adding Ospf Areas To The Cable Interface - SMC Networks SMCD3GN3 Administrator User Manual

Adding OSPF Areas to the Cable Interface

To add OSPF areas to the cable interface:
1. In the OSPF Control menu, be sure OSPF Status is set to ENABLE. Otherwise, you will
not be able to add OSPF areas to the cable interface.
2. Click the Add button below the Additional OSPF area Table. The Adding OSPF Area
menu appears (see Figure 41).
3. Complete the fields in the Adding OSPF Area menu (see Table 16).
4. Click Apply. (Or click Back to return to the OSPF Control menu or Cancel to cancel any
selections you made.) If you clicked Apply, the OSPF area is added to the Additional
OSPF area Table.
5. To configure additional OSPF area (up to 5), repeat steps 1 through 4. When you finish,
click Apply in the OSPF Control menu to save your settings.
6. To change the settings for an OSPF area, click the radio button to the left of the OSPF
area you want to change and click the Edit button. When the Adding OSPF Area menu
appears, edit the settings as necessary (see Table 16) and click Apply.
7. To delete a predefined service, click the radio button to the left of the OSPF area you want
to delete and click the Delete button. No precautionary message appears before you
delete an OSPF area.
8. Click Apply on the OSPF Control menu.
SMCD3GN2 Wireless Cable Modem Gateway Administrator Manual
錯誤! 尚未定義樣式。
81