Cable Routing For 2.5-Inch Drives To Two Backplanes - Lenovo ThinkSystem SR860 Setup Manual

Four processors installed
Figure 30. Cable routing, AnyBay backplane
Note: Install the processor and memory expansion tray before connecting the signal cables to NVMe
connector on the expansion tray.
Table 23. Cables and adapters for routing
1
SATA/SAS RAID adapter (8i)
2
NVMe connectors on the processor and memory
expansion tray

Cable routing for 2.5-inch drives to two backplanes

Use this section to understand how to route cables for 2.5-inch drives to two backplanes.
Following is the list of combinations of cable routing for 2.5-inch drives to two backplanes.
• "Connecting signal cables to two backplanes" on page 41
– "8-bay backplane + 8-bay backplane" on page 41
– "AnyBay backplane + 8-bay backplane " on page 43
– Two processors installed
3
Direct NVMe signal cables for processor and memory
expansion tray
4
SATA/SAS signal cables (720 mm)
Chapter 2
. 39
Server components