Install A 2.5-Inch Hot-Swap Drive - Lenovo ThinkSystem SR860 Setup Manual

Figure 60. Drive bay labels of both NVMe and SATA/SAS drives
Table 40. Drive bay labels of both NVMe and SATA/SAS drives
1
Drive bay 4-7 label of both NVMe and SATA/SAS
drives
After installing the drive backplane, complete the following steps:
1. Connect the cables to the drive backplane. If the type of drive backplane is changed, it is necessary to
reroute the signal cables (see "Internal cable routing" on page 33 for detailed instructions).
2. Install the drives (see "Install a 2.5-inch hot-swap drive" on page 77).
3. If the system board air baffle or the processor and memory expansion tray and processor and memory
expansion tray air baffle have been removed, install them (see "Install the system board air baffle and the
power interposer" on page 80 or "Install the processor and memory expansion tray " on page 81).
4. Install the chassis air baffle (see "Install the chassis air baffle" on page 93).
5. Install the top cover (see "Install the top cover" on page 97).
6. Reconnect the power cords and any cables that you removed.
7. If the server is installed in a rack, reinstall the server into the rack.
8. Power on the server and any peripheral devices.

Install a 2.5-inch hot-swap drive

Use this procedure to install a 2.5-inch drive.
Following are the types of drives supported by this server:
• NVMe solid-state drive
• SATA/SAS solid-state drive
• SATA/SAS hard-disk drive
For a complete list of supported optional device for this server, see http://www.lenovo.com/serverproven/.
Before installing a 2.5-inch hot-swap drive:
1. Read the safety information and installation guidelines (see "Safety" on page iii and "Installation
Guidelines" on page 58).
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
2
Drive bay 12-15 label of both NVMe and SATA/
SAS drives
Chapter 3
. 77
Server hardware setup