Lenovo ThinkSystem SR860 Setup Manual page 86
Hide thumbs
Also See for ThinkSystem SR860:
- Maintenance manual (212 pages) ,
- Setup manual (172 pages) ,
- Product manual (65 pages)
Table of Contents
Advertisement
To install a 2.5-inch drive, complete the following steps:
Step 1.
Determine the available drive bays based on the drive bay labels applied. The following labels
indicate that the drive bays support both NVMe and SATA/SAS drives. Otherwise, only SATA/SAS
drives are supported.
Figure 61. Drive bay labels of both NVMe and SATA/SAS drives
Table 41. Drive bay labels of both NVMe and SATA/SAS drives
1
Drive bay 4-7 label of both NVMe and SATA/SAS
drives
Notes:
1. Make sure to install the correct type of drives into supported by corresponding drive bays.
Drive type information is available on the drive.
Step 2.
Remove the drive bay filler if it has been installed in the drive bay.
Step 3.
Gently rotate the release latch away to unlock the drive handle.
Step 4.
Slide the drive into the drive bay, and push it until it stops.
Figure 62. Drive installation
Step 5.
Rotate the drive-tray handle back to the locked position.
After installing the 2.5-inch hot-swap drive, check the drive status LED to verify if the drive is operating
correctly:
• If the yellow LED is lit continuously, it is malfunctioning and must be replaced.
78
ThinkSystem SR860 Setup Guide
2
Drive bay 12-15 label of both NVMe and SATA/
SAS drives
Advertisement
Table of Contents
