Install The System Board Air Baffle And The Power Interposer - Lenovo ThinkSystem SR860 Setup Manual

Install the system board air baffle and the power interposer

Use this procedure to install the system board air baffle and the power interposer.
Before installing the system board air baffle:
1. Read the safety information and installation guidelines (see "Safety" on page iii and "Installation
Guidelines" on page 58).
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
To install the system board air baffle, complete the following steps:
Step 1. Slightly slide power supply 2 out from the power supply bay (see "Remove a hot-swap power
supply unit" in ThinkSystem SR860 Maintenance Manual).
Step 2. Align the power interposer to the server, and lower it until it sits firmly in place.
Figure 64. Power interposer installation
Step 3. Align the two pairs of nailheads of the system board air baffle to slots, and lower it into the server.
Attention: Air baffle is required for airflow that creates proper cooling. Make sure proper air baffle
(s) for system configuration is installed before the power is turned on.
80
ThinkSystem SR860 Setup Guide