Figure 79. M.2 drive installation
Attention: When sliding the retainer forward, make sure the two nubs on the retainer enter the
small holes on the M.2 backplane. Once they enter the holes, you will hear a soft "click" sound.
Figure 80. M.2 drive installation with the retainers in place
After installing an M.2 drive in the M.2 backplane, see "Install the M.2 backplane" on page 91 to complete
installation.
Install the M.2 backplane
Use this procedure to install the M.2 backplane.
Before installing the M.2 backplane:
1. Read the safety information and installation guidelines (see "Safety" on page iii and "Installation
Guidelines" on page 58).
2. Install an M.2 drive to every available connector on the M.2 backplane (see "Install an M.2 drive in the
M.2 backplane" on page 90).
3. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
.
Chapter 3
Server hardware setup
91